MPA Optimization Area closed not working

[joeb]

When running the MPA optimization under the Importance layer mode it seems the the Area closed (min %) and Area close (max %) are not used

• Load the MPA optimization form.
• Set the Search type to Importance layer.
• Make sure there is some kind of an MPA loaded.
• set Area closed min and max, 5-50.
• set Step % 5.
• Iteration 5, make this a small enough number that you can wait for it to run, you can also set the Ecospace run length to something smaller so it runs faster.
• Run it and wait for the output.
• In the Map input tab you can see the iteration, as the Area size changes you should be able to tell by the number of MPA cells on the map.
• From the Results tab you should be able to select the different Area closed(%) for output but it does not seem to work only the default of 20% is available.

[joeb]

Ok this seems to be working now. I'm not sure if it was broken or I was using it wrong.