Ecosim Output- general screen issues

[carieh]

using the Tampa bay model:
Basically I just imported the model, and ran it in Ecosim. The output looked the same as in version 5, and I tried to use the S/R plot and the equilibrium plot screens, but they are not showing up. Perhaps they are not finished yet?

So then I tried to run Ecosim altering the fishing mortality of the groups- which is hard to tell if it workd with so many groups, and such a range of dynamics already.

When I switch to individual groups on the bottom, I noticed you added a line at 1 (as to avoid the usual confusion) thanks. Also I cannot figure out how to get the graph to show only one group, the one I am testing while running the model. I can make it so the rest of the groups are grey, but for example I chose Bay anchovies, and played around with the mortality in the drawing screen on the bottom. So I increased the mortality, and then ran the model again, and even though Bay anchovy (group #25) was selected (and showed a blue line) when the model ran it went back to showing the first group (#1 0-12 snook-
so maybe it is better if you have selected a group to watch on the run, that that particular group remains on the screen instead of switching to the first group, which is the default- I am assuming.

If I overlay the ecosim runs, then specify which group I want to look at it is very nice that each group shows up with 3 lines- very easy to read.

[shermanl]

SL: Fang, maybe it might be nice to have that All group on the top of the Group Tab. Selecting this would turn on all the colors on the graph.

[user8]

1. All groups has been added
2. Nav panel's S/R plot and the equilibrium are removed. Not sure if we will have that for now.
3. To show for individual groups, use Hide groups button for a separate UI.
4. The previous selected group will be there instead of returning to the first group.